 valve train geometry |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| TheCabinetmaker |
 Jan 24 2011, 07:36 AM
Post
#1
|
|
I drive my car everyday  Group: Members Posts: 8,301 Joined: 8-May 03 From: Tulsa, Ok. Member No.: 666  |
Does this look okay to you guys? This is at half lift.
(IMG:http://www.914world.com/bbs2/uploads_offsite/i290.photobucket.com-666-1295876202.1.jpg) (IMG:http://www.914world.com/bbs2/uploads_offsite/i290.photobucket.com-666-1295876203.2.jpg) |
   |
 
|
  |
Replies
| Jake Raby |
Jan 24 2011, 07:11 PM
Post
#2
|
|
Engine Surgeon Group: Members Posts: 9,394 Joined: 31-August 03 From: Lost Member No.: 1,095 Region Association: South East States |
Looks like you need a bit more trimmed off the rocker face.. And some HD rocker studs/ nuts. Alignment looks ok.
Clean that dust off those components!! |
 |
|
Posts in this topic
vsg914 valve train geometry Jan 24 2011, 07:36 AM
Vacca Rabite Looks pretty good. Seems like you are on the same... Jan 24 2011, 08:50 AM nathansnathan Looks like the 911 adjuster is hitting the rocker,... Jan 24 2011, 09:14 AM
Vacca Rabite
Looks like the 911 adjuster is hitting the rocker... Jan 24 2011, 11:33 AM rhcb914 I don't mean to pick on you but I really hope ... Jan 24 2011, 10:51 AM r_towle Rockers do not appear to have been clearanced enou... Jan 24 2011, 01:04 PM Cevan My rockers were faced and I ended up needing .030 ... Jan 24 2011, 01:15 PM toon1 X2 Jan 24 2011, 02:58 PM vsg914 Thanks for the replies. Don't worry about ... Jan 24 2011, 04:52 PM nathansnathan About .060" off the rockers puts that surface... Jan 24 2011, 05:14 PM vsg914 Is there a minunum thickness the rockers can be?
... Jan 24 2011, 08:19 PM r_towle good rule of thumb for any threaded fastener is yo... Jan 24 2011, 10:35 PM Jake Raby ANY time I have to use shims to correct geometry I... Jan 25 2011, 07:15 AM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 2nd June 2024 - 07:02 AM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.