 Cup holder |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| partwerks |
 Apr 6 2011, 05:40 PM
Post
#1
|
|
Senior Member  Group: Members Posts: 1,619 Joined: 7-September 06 From: Grand Island, NE Member No.: 6,787  |
  Got tired of my coffee spilling on the console when flying around the corners and so I decided to make a holder for it. I just cut the over sized hole for the cup in question with a hole saw and formed it up and drilled out the pop rivets and riveted it in place and put a piece of tubing around the inside to cover any sharp edges. |
   |
 
|
  |
Replies
| partwerks |
Apr 6 2011, 08:19 PM
Post
#2
|
|
Senior Member Group: Members Posts: 1,619 Joined: 7-September 06 From: Grand Island, NE Member No.: 6,787 |
There was a place that made the part that slides in and in place of the ash tray they had where you could place a couple cans and a cell phone for about $50.00
I just piggy backed off of that idear. |
|
|
|
Posts in this topic
partwerks Cup holder Apr 6 2011, 05:40 PM
Elliot Cannon Maybe you should be concentrating on "flying ... Apr 6 2011, 05:57 PM partwerks I can multi task. :beer3: Apr 6 2011, 06:06 PM kg6dxn Nice job! :trophy: I had to make one too. Lit... Apr 6 2011, 07:37 PM
bigkensteele
Nice job! :trophy: I had to make one too. Li... Apr 6 2011, 08:44 PM kg6dxn
Why in the hell would you fabricate a nice cuphol... Apr 6 2011, 09:05 PM raw1298 Since I quit smoking 21 years ago, maybe I can fab... Apr 6 2011, 07:44 PM dirk9141973 :Qarl: I sure need to make one the only one that w... Apr 6 2011, 07:50 PM smontanaro Garold did something involving a store bought cup ... Apr 6 2011, 08:35 PM KillerDucks Maybe a silly question but what the heck is that?
... Apr 6 2011, 09:02 PM kg6dxn
Maybe a silly question but what the heck is that?... Apr 6 2011, 09:07 PM jim_hoyland I made a cup holder from two PVC plubling parts. S... Apr 6 2011, 09:12 PM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 2nd April 2026 - 01:05 PM |
Invision Power Board
v9.1.4 © 2026 IPS, Inc.