 ignition switch - how do i install it? |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| tod914 |
 Apr 15 2003, 10:18 AM
Post
#1
|
|
Advanced Member  Group: Members Posts: 3,755 Joined: 19-January 03 From: Lincoln Park, NJ Member No.: 170  |
my 75 2.0 ign switch is on the way out - new 1 comming wed. how do i install it? didnt see any tech arts on it.
Thanks! |
   |
 
|
  |
Replies
| Chris H. |
Apr 15 2003, 10:34 AM
Post
#2
|
|
Senior Member Group: Members Posts: 4,032 Joined: 2-January 03 From: Chicago 'burbs Member No.: 73 Region Association: Upper MidWest 
|
I think I have some directions, but essentially you have to take the steering wheel off, unscrew the wipers and turns (I think), then there will be a single bolt holding the switch in. Unbolt that, and if you are just swapping out the white part that is behind the key I think you slide that out the back, slide the new one in, put it all back together and you're done. I just swapped the entire cylinder, key and all, with another one, so I'm not positive how to get the white portion out....
DON"T FORGET TO MARK THE STEERING WHEEL POSITION!!! Otherwise it's a bitch to get lined back up. |
|
|
|
Posts in this topic
|
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 11th June 2024 - 12:52 PM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.