floorpan replacement process Options

[shuie]

Rust is so weird. The outer longs, suspension consoles, and hellhole in my car are rock steady, but my floors have rusted from the inside out and are completely shot.

Here's a pic of the DS. I thought I might be able to save some of this, so I pulled the sound deadener up and found it was rusting from the inside out. I didnt bother getting pics of the passenger side. It was pretty obvious it was gone once I started poking around.

(IMG:https://lh6.googleusercontent.com/-EFzWlIxugUI/TraPcBRbKdI/AAAAAAAAKH0/tJROzhoMIsc/s800/IMG_0141.jpg)

I need to replace the entire floorpan. Both crossmembers need to be replaced as well as the triangles with the jacking donuts. I will also be doing some patch work around the perimeter of the floor, inner longs, around the center tunnel, etc..

What is the best strategy for this kind of job? I know I need to brace the doors before I start cutting. Whats the best way to keep the tub supported properly and NOT remove too much metal at one time? Should I leave most the floorpan in place along the center tunnel section and do the patchwork along the inner longs and perimeter of the floors first? For the replacement panels, does it make more sense to use the front and rear halves, or the left and right halves on a job like this?

And, how bad of a job is this without a rotisserie? I don't know enough about these cars to know how the different layers of the metal get sandwiched together in the floor area yet. Can I weld the floor pans in from the top, from inside the passenger compartment? Or, will I have to weld overhead?

TIA.

[Vysoc]

Ironic,

I am doing the same thing you are and after ripping the tar off the floor my floor looks almost exactly the same.
I have the room and have decided to build a rotisserie.

Does anyone sell the door bar supports?

Looks like I will be replacing at least the rear section of the floorpan on both sides, I have not cleared all the tar off the front area yet, so not sure what lies up front, look like the area under the pedals is very thin.

I have purchased the Engman Long kit and am wanting to make sure that the floors are solid prior to welding that strengthening platform in.

It is really amazing how the floor boards rust from the inside, but when you think about it if the car was stored outside, it never had a chance, water would get in somehow.

TIN WORM BLUES.

Vysoc

[shuie]

I have the room and have decided to build a rotisserie.

Does anyone sell the door bar supports?

Yes, the first pic I posted is actually from the Tangerine Racing website. They sell that setup. They also sell a rotisserie. I'm going to call them to get dimensions on the rotisserie to make sure it won't fit in my garage. I'd rather buy these tools and resell them when I'm done than make them myself.