Timing Question, Got the dizzy out - crisis averted Options

[bigkensteele]

Question: I can only see the timing mark on the impeller when the rotor is in the 2 and 4 position. When I had the engine on a stand, I could see it at 1. What gives?

Lead-up story: As some of you may have read, I finally got my car running on Sunday after a total reseal project. It is a 1.8 with L jet, and I installed a pertronix while the motor was out. I also replaced the dizzy O ring, but I never loosened the timing plate.

I was able to get it started on Sunday, and it ran pretty rough for a while and finally warmed up to a point where it was running OK at best.

Knowing that the timing was only in the ballpark, last night, I had the brilliant idea of loosening the plate and do a little tweaking. I went a bit to far and it died. (IMG:style_emoticons/default/barf.gif) So I moved it back to the approximate starting position, and it would not start.

That is when I decided to do it the right way, but I now my timing mark doesn't show when the rotor is on 1. (IMG:style_emoticons/default/mad.gif) (IMG:style_emoticons/default/headbang.gif) (IMG:style_emoticons/default/ar15.gif)

[Gint]

(IMG:style_emoticons/default/agree.gif)

If there is no downward pressure on the dizzy and you turn the rotor (loosen the clamp and pull the dizzy up a millimeter or two), if the teeth aren't engaged on the drive gear, you'll know it right away because it will turn. If the teeth are engaged, the rotor won't turn. And if the teeth are riding up on top of the drive gear, turning the rotor should enable you to re-engage them.

If it still won't start, go back to #1 TDC and start over.