 Gas tank bungs leaking..., Any tricks to make them seal better? |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| bigkensteele |
  Nov 19 2011, 07:33 PM
Post
#1
|
|
Major Member  Group: Members Posts: 2,200 Joined: 30-August 04 From: Cincinnati, OH Member No.: 2,660 Region Association: South East States 
 |
I pulled the tank and completely re-plumbed my fuel system, including new little red seals on the bungs at the bottom of the tank. Cleaned all the hardware thoroughly before re-assembly.
Now, the garage smells like a refinery. Unfortunately, the bungs are leaking like crazy. Not quite dripping, but they are wet enough to be the obvious source of my leak. Any tips on getting them sealed up properly? Is there only supposed to be one little red seal on each bung, or two? |
   |
 
|
  |
Replies
| mark21742 |
Nov 23 2011, 08:21 AM
Post
#2
|
|
Member Group: Members Posts: 162 Joined: 31-August 11 From: pa Member No.: 13,502 Region Association: North East States |
If you can't get it to seal, just run down here to south Pa and grab my stock gas tank.....its here, its out, its good, and its free (IMG:style_emoticons/default/smile.gif)
|
|
|
|
Posts in this topic
bigkensteele Gas tank bungs leaking... Nov 19 2011, 07:33 PM
kg6dxn I would use a copper washer to seal it. The seal s... Nov 19 2011, 08:47 PM
bigkensteele
I would use a copper washer to seal it. The seal ... Nov 19 2011, 09:05 PM kg6dxn Go to harbor freight and buy the copper washer kit... Nov 19 2011, 09:17 PM bigkensteele
Go to harbor freight and buy the copper washer ki... Nov 19 2011, 10:24 PM r_towle I have heard of others using AN fittings and tappi... Nov 23 2011, 08:28 AM 9146986 Lap the fittings together. Tighten the sleeve nut... Nov 23 2011, 09:08 AM kconway If you want to use AN fittings check this out, no ... Nov 23 2011, 09:28 AM bigkensteele I ended up pulling the tank and filing the mating ... Nov 23 2011, 09:30 AM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 4th July 2025 - 03:56 PM |
Invision Power Board
v9.1.4 © 2025 IPS, Inc.