6 conversion with a 911 to pull from Options

[newto914s]

I’ve read a number of old postings on estimating the cost in converting a 4 to a 6. Minus the brakes and suspension, anywhere from 5k to 15k or more.
My question is what if you use a 911 parts car.
I figure you can get a 911 project/parts car between $2000 and $4000.
I would think suspension wise you could lift just about all of it off the 911 and throw it onto your 914.
Engine wise I would have thought the same thing until reading all those old posting(engine mounts, Five piece, OE style, steel reproduction engine sheet metal sets, oil cooler modification, OE oil tanks, oil tank hardware and metric oil lines, Rear sift modification for side shifter transmissions, Accelerator linkage kits for carbs)

How much could you use from a 911(69-73) to make the conversion?

Obviously, there is a flaw in this thinking. Putting old parts from a run down 911 isn’t really upgrading compared to putting “new” parts on. Where is the savings if you have to rehab all the parts before installing them, and if the parts are in such good shape why not just rehab the 911 instead? For conversation sake we’ll just assume the parts are roadworthy and I would prefer to drive a 914 over a 911.

Thanks
Sam

[Dr Evil]

John,
How did you use the 915 trans and 911 shifter bits? I have a 74 911 parts car that I can get conversion parts from and I am interested in what to covet, and what to sell.

newto914s,
I will have a full suspention available for you soon if you are interested as well as other parts as al I am using is the engine and maybe the drive train.