ring & pinion mesh, is this right? |
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
ring & pinion mesh, is this right? |
Chris914n6 |
May 22 2004, 01:00 PM
Post
#1
|
Jackstands are my life. Group: Members Posts: 3,332 Joined: 14-March 03 From: Las Vegas, NV Member No.: 431 Region Association: Southwest Region |
inside high, outside low.
At .2mm spacer gap. Attached image(s) |
KenH |
May 22 2004, 08:27 PM
Post
#2
|
Senior Member Group: Members Posts: 680 Joined: 16-January 03 From: Gilroy, CA Member No.: 156 |
Ideally the it should show contact in the middle section of the teeth.
I would try to move it a bit closer. Do not forget to check the Diff. Cover pre-load dimension. Ken |
Lo-Fi Version | Time is now: 6th June 2024 - 06:25 AM |
All rights reserved 914World.com © since 2002 |
914World.com is the fastest growing online 914 community! We have it all, classifieds, events, forums, vendors, parts, autocross, racing, technical articles, events calendar, newsletter, restoration, gallery, archives, history and more for your Porsche 914 ... |