 Weber 44 IDF mixture help needed |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| tornik550 |
 Sep 5 2012, 08:11 PM
Post
#1
|
|
Senior Member  Group: Members Posts: 1,248 Joined: 29-January 07 From: Ohio Member No.: 7,486 Region Association: None  |
I am working on getting my idle jets correct. My mains seem ok.
At idle (800 rpm) I am getting a reasonable air fuel ratio (14.8 using innovate a/f gauge). I'm using 50 size idles. If I slightly press and hold the peddle to a steady 1200 to 2000 rpm the a/f goes to 19. The car drives like crap until I reach 2000 rpm when the main jets kick in- at the same time the a/f ratio goes to 14 or so. What adjustments can I make that will leave idle at the same mixture however rich up the mixture til about 2000 rpms? I thought that was mainly idle just only? I did try to increase the idle jet size to 55. The idle mixture goes down to 11.8 at 800rpm and is perfect between 1200 to 2000 rpm. Confused- I can either get the idle correct OR the low rpms? I have followed weber's info on best lean each time I switched jets. Ideas? What am I missing- i'm sure its something simple. |
   |
 
|
  |
Replies
| mrbubblehead |
Sep 6 2012, 04:48 PM
Post
#2
|
|
Twodollardoug Group: Members Posts: 1,155 Joined: 17-December 10 From: calimesa ca. Member No.: 12,492 Region Association: Southern California |
your idle/progressive circuit is behaving exactly as it was designed to.
|
|
|
|
Posts in this topic
tornik550 Weber 44 IDF mixture help needed Sep 5 2012, 08:11 PM
mrbubblehead it sounds like your close. does the car sputter an... Sep 5 2012, 08:20 PM
tornik550
it sounds like your close. does the car sputter a... Sep 5 2012, 08:49 PM cgnj Hi,
What size motor, What size vent are you runni... Sep 5 2012, 08:35 PM tornik550 I don't understand how I can Make the mixture ... Sep 6 2012, 04:39 PM mrbubblehead
I don't understand how I can Make the mixture... Sep 6 2012, 04:45 PM toolguy The idle jets set the mixture for progression hole... Sep 6 2012, 05:48 PM tornik550 I increased my idle jet size to 55. Now the engin... Sep 6 2012, 06:49 PM toolguy How does it run when it's cold and just starte... Sep 7 2012, 10:34 AM tornik550
How does it run when it's cold and just start... Sep 7 2012, 09:00 PM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 9th May 2025 - 10:34 AM |
Invision Power Board
v9.1.4 © 2025 IPS, Inc.