 Trailing arm bearing, removal trick?? |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| toon1 |
 Oct 25 2012, 11:25 AM
Post
#1
|
|
Senior Member  Group: Members Posts: 1,849 Joined: 29-October 05 From: tracy,ca Member No.: 5,022  |
Does anyone have a trick to remove the bearing from the trailing arm without ruining it?
I ran into a problem while doing my 5 lug conversion. |
   |
 
|
  |
Replies
| Eric_Shea |
Oct 25 2012, 11:40 AM
Post
#2
|
|
PMB Performance Group: Admin Posts: 19,278 Joined: 3-September 03 From: Salt Lake City, UT Member No.: 1,110 Region Association: Rocky Mountains  |
You really need a press and a proper sized drift to distribute the load evenly across the available bearing surface to get it out without (hopefully) damaging it.
If'n it were me, I'd write of the $50.00 clams as an edu-ma-cation fee and get a new one. |
|
|
|
Posts in this topic
toon1 Trailing arm bearing Oct 25 2012, 11:25 AM
yeahmag It's accepted that the process of removing the... Oct 25 2012, 11:40 AM toon1
You really need a press and a proper sized drift ... Oct 25 2012, 12:09 PM yeahmag Nope, but if they are original they are most likel... Oct 25 2012, 12:10 PM wingnut86 :agree:
Search the threads here and on The Pelic... Oct 25 2012, 12:49 PM Cap'n Krusty To add to the chorus. The very act of pressing th... Oct 25 2012, 01:18 PM
02loftsmoor Cap'n have you heard of any wheel bearing fail... Oct 25 2012, 01:22 PM
wingnut86 Hey Wes,
If it sits for 17 years in a dry climate... Oct 25 2012, 02:46 PM 6freak the same why ya put them in ...press the outer rac... Oct 25 2012, 02:31 PM Cap'n Krusty
the same why ya put them in ...press the outer ra... Oct 25 2012, 03:47 PM SirAndy I remember someone (a loooong time ago) posted a f... Oct 25 2012, 03:01 PM matthepcat Just order new bearings now. Ask me how I know. :... Oct 25 2012, 03:40 PM toon1 one of the bearings dropped right into the trailin... Oct 25 2012, 04:23 PM Cap'n Krusty Pretty hard to unbolt the cover over the bearing w... Oct 25 2012, 04:41 PM Eric_Shea You have the hub in there already? Scrap it and g... Oct 25 2012, 05:36 PM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 10th June 2024 - 07:13 AM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.