 Am I doing this correctly? Checking end play |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| tornik550 |
 Dec 18 2012, 07:22 PM
Post
#1
|
|
Senior Member  Group: Members Posts: 1,248 Joined: 29-January 07 From: Ohio Member No.: 7,486 Region Association: None  |
Just want to double check that I am doing this correctly. I am checking my end play. The engine is assembled. I put a magnetic dial indicator mount on my flywheel and placed the point of the indicator on a parallel flange on the case. I then pulled the flywheel away from the case and took a measurement. Then pushed the flywheel into the case as much as possible and took a measurement. The difference between the two measurements is the end play. Mine was .005.
Does my technique sound correct? Am I missing anything? Is .005 acceptable? Thanks. |
   |
 
|
Posts in this topic
Mark Henry I bolt mine to the case and measure the flywheel.
... Dec 18 2012, 07:50 PM
tornik550 I went outside and decided to recheck my work. I ... Dec 18 2012, 09:32 PM  |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 9th May 2025 - 12:29 PM |
Invision Power Board
v9.1.4 © 2025 IPS, Inc.