 choking dual carbs? |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| last337 |
 Feb 5 2013, 09:24 AM
Post
#1
|
|
Member  Group: Members Posts: 421 Joined: 4-December 12 From: New Orleans Member No.: 15,221 Region Association: None  |
I had a lot of trouble the other day getting my engine to start. I eventually had to enrich each barrel to get it to fire up then lean it out a bit to smooth my idle a bit after it warmed up. Is there a way to choke these carbs initially to prevent this? Is there an easier way to start the engine when cold?
|
   |
 
|
  |
Replies
| rhodyguy |
Feb 5 2013, 04:43 PM
Post
#2
|
|
Chimp Sanctuary NW. Check it out. Group: Members Posts: 22,240 Joined: 2-March 03 From: Orion's Bell. The BELL! Member No.: 378 Region Association: Galt's Gulch |
a grand for a muffler? you can put together a COMPLETE system that allows you the option of heat when you want it for far less than that. you're going to want heat. let me know if that pm helps with your high idle.
k |
|
|
|
Posts in this topic
last337 choking dual carbs? Feb 5 2013, 09:24 AM
rhodyguy what is your warm engine idle speed? unless your w... Feb 5 2013, 10:11 AM mrbubblehead :agree:
when properly tuned, just a few pumps on... Feb 5 2013, 12:31 PM SUNAB914 When cold turn ignition so that fuel pump runs and... Feb 5 2013, 12:36 PM last337 I will try again and see how it goes. It runs gre... Feb 5 2013, 02:41 PM
wndsrfr
I will try again and see how it goes. It runs gr... Feb 6 2013, 07:08 AM brant obx headers are a night mare...
go with SSI heat ... Feb 5 2013, 02:44 PM rhodyguy well he may not need heat in NO but if he should e... Feb 6 2013, 08:08 AM last337 My current heat exchangers are not all that bad ju... Feb 6 2013, 08:25 AM brant
My current heat exchangers are not all that bad j... Feb 6 2013, 09:14 AM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 9th May 2025 - 09:58 AM |
Invision Power Board
v9.1.4 © 2025 IPS, Inc.