 Bearing do i need to take 2 steps back?, Silverline vs. others |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| jmargush |
 Mar 10 2013, 11:43 AM
Post
#1
|
|
Member  Group: Members Posts: 487 Joined: 8-June 04 From: Goshen, IN Member No.: 2,176  |
I am in the middle of a 2056 build and have started to assemble the short block.
The bearings I bought are Silverline, in the past two days or so I have been checking some things and have seen several posts about Silverline bearings being inferior. The case isn't closed yet. So should I pull the the gears back off the crank and source some other main and cam bearing from another manufacture? Jeff |
   |
 
|
  |
Replies
| jmargush |
Mar 10 2013, 12:55 PM
Post
#2
|
|
Member Group: Members Posts: 487 Joined: 8-June 04 From: Goshen, IN Member No.: 2,176 |
mine are steel backed
|
|
|
|
Posts in this topic
jmargush Bearing do i need to take 2 steps back? Mar 10 2013, 11:43 AM
CMONNETT I would use other bearings. Check the samba for N... Mar 10 2013, 12:15 PM stugray Order a new set from Jake. If he sells them, they ... Mar 10 2013, 12:44 PM jmargush I ordered these new from European Motorworks back ... Mar 10 2013, 12:49 PM
Katmanken It's important that the crank and rod bearings... Mar 10 2013, 01:00 PM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 16th September 2025 - 04:53 AM |
Invision Power Board
v9.1.4 © 2025 IPS, Inc.