 Rear trunk seal separation, ?? |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| xperu |
 Mar 19 2013, 01:27 PM
Post
#1
|
|
TEXAS  Group: Members Posts: 597 Joined: 13-June 06 From: League City Texas Member No.: 6,213 Region Association: None 
 |
This morning I was putting my top into my truck and forund the round bead seperating from the bottom portion of the seal. The seal is ony 2 years old. Anyone experience this? Fix suggestion or do I need to replace. My car is a garage baby so I can only assume a bad product run. Mike
|
   |
 
|
  |
Replies
| Mikey914 |
Mar 22 2013, 09:43 AM
Post
#2
|
|
The rubber man Group: Members Posts: 12,772 Joined: 27-December 04 From: Hillsboro, OR Member No.: 3,348 Region Association: None
|
Well, for bonding superglue works very well. You can get the control gel and put a thin line where it's needed. Apply just enough pressure to bod it so it's not collapsed and bonding parts you don't want.
Shoot some pictures I'd like to see what's going on here. Also, where did you get the seal? -Mark |
|
|
|
Posts in this topic
xperu Rear trunk seal separation Mar 19 2013, 01:27 PM
ThePaintedMan
This morning I was putting my top into my truck a... Mar 19 2013, 02:01 PM ThePaintedMan
This morning I was putting my top into my truck a... Mar 19 2013, 02:01 PM Pat Garvey Replaced that seal 31 years ago with a non-factory... Mar 19 2013, 06:08 PM
xperu
Replaced that seal 31 years ago with a non-factor... Mar 21 2013, 10:49 AM xperu
Well, for bonding superglue works very well. You ... Mar 22 2013, 12:00 PM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 1st July 2025 - 07:05 AM |
Invision Power Board
v9.1.4 © 2025 IPS, Inc.