 Transmission is out of the car |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| malcolm2 |
 May 27 2013, 02:22 PM
Post
#1
|
|
Advanced Member  Group: Members Posts: 2,747 Joined: 31-May 11 From: Nashville Member No.: 13,139 Region Association: South East States 
 |
Just curious, with the tranny out of the car, should you be able to shift at all?
No oil currently in it either. I have never driven this car, it was parked in 2001. I think the good Dr. answered a similar question a while back. IIRC his answer was the only way to test in this state was to install it. Is that the answer to this?  Should I be able to move this lever up or down and engage the gears? In or out and engage other gears? SIMULATE driving? |
   |
 
|
  |
Replies
| pcar916 |
May 27 2013, 02:52 PM
Post
#2
|
|
Is that a Lola? Group: Members Posts: 1,523 Joined: 2-June 05 From: Little Rock, AR Member No.: 4,188 Region Association: None
|
You can shift it but it may not easily go into all of the gears. In and out of the trans will select which gear-"pair" you're in (1st-rev, 2nd-3rd, or 4th-5th, each on a different plane) and front to back will select which of those gears is engaged in that plane.
The input shaft needs to be rotated a bit sometimes as the shift pattern is executed. Sitting vertical like shown, make sure the transaxle bell housing is supported (like on two 2x4's) so that the input shaft isn't sitting on the floor keeping the trans from sitting flat. Good luck |
|
|
|
Posts in this topic
malcolm2 Transmission is out of the car May 27 2013, 02:22 PM
malcolm2
You can shift it but it may not easily go into al... May 27 2013, 07:25 PM Dave_Darling Yes, it should be possible. But you have a whole ... May 27 2013, 04:29 PM malcolm2
Yes, it should be possible. But you have a whole... May 27 2013, 07:22 PM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 12th July 2025 - 04:07 PM |
Invision Power Board
v9.1.4 © 2025 IPS, Inc.