 Jug size |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| ruddyboys |
 Jul 8 2004, 01:16 PM
Post
#1
|
|
Hummel eigentümer  Group: Members Posts: 595 Joined: 3-March 04 From: Monroe, NY Member No.: 1,749 Region Association: North East States  |
Is the outside diameter of a bigbore 96mm jug the same as the stock diameter?
|
   |
 
|
  |
Replies
| Joe Ricard |
Jul 8 2004, 03:28 PM
Post
#2
|
|
CUMONIWANNARACEU Group: Members Posts: 6,811 Joined: 5-January 03 From: Gautier, MS Member No.: 92 |
Don't believe seas will fix this. However since you need to pulle the top end off the motor anyway have the cylinder lapped to the case and head. Then Apply the correct torque you will be fine. Little bit of orange/ copper permatex THIN LAYER at the case end. No more leaks.
|
|
|
|
Posts in this topic
ruddyboys Jug size Jul 8 2004, 01:16 PM
bondo Aww, that's not what I was hoping this thread ... Jul 8 2004, 01:18 PM seanery A 96mm will fit in place of a 2.0 liter's 94mm... Jul 8 2004, 01:19 PM ruddyboys OK so if I need to order seals for the head and bl... Jul 8 2004, 01:23 PM seanery I'm learning this as I go but, No seals betwee... Jul 8 2004, 01:43 PM 74914LE You will need to have the heads milled out to fit ... Jul 8 2004, 01:53 PM seanery In my reading on the jug sizes, I've read a co... Jul 8 2004, 02:12 PM tat2dphreak Sean... with 1.8 Heads you should be ok too... 1.8... Jul 8 2004, 02:20 PM James Adams All cases have the same spigot size.
1.7 head reg... Jul 8 2004, 02:24 PM ruddyboys I have the 96mm installed already, I am getting an... Jul 8 2004, 03:04 PM markb 
WoMBaT QUOTE
|
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 3rd July 2025 - 11:27 PM |
Invision Power Board
v9.1.4 © 2025 IPS, Inc.