 Removing Ball Joints, ball joint nut..where to get the tool? |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| jim912928 |
 Jul 9 2004, 08:27 AM
Post
#1
|
|
Senior Member  Group: Members Posts: 1,487 Joined: 8-January 04 From: Granger, IN Member No.: 1,536 Region Association: Upper MidWest  |
I'm going to be replacing the ball joints on my control arms...the control arms are off the car. This looks like it takes some weird socket with 4 notches on it. Since there is no porsche dealership even close to me...where does one get this tool? And are there any tricks to the trade I should know about before I start cranking on it?
Thanks in advance. |
   |
 
|
  |
Replies
| KenH |
Jul 9 2004, 09:25 AM
Post
#2
|
|
Senior Member Group: Members Posts: 680 Joined: 16-January 03 From: Gilroy, CA Member No.: 156 |
A large pipe wrench will remove & install them.
It is difficult to hold the the "special tool" so it does not slip. I hold the "special tool" in place with a board on top of my floor jack and jack the suspension up to it where it just starts to lift the car. Ken |
|
|
|
Posts in this topic
jim912928 Removing Ball Joints Jul 9 2004, 08:27 AM
rhodyguy if you have a compressor and a air chisel it will ... Jul 9 2004, 08:35 AM Bigbohr I bought that socket from Pelicanparts. Use with i... Jul 9 2004, 08:37 AM ArtechnikA prelubricate with some real penetrating oil (like ... Jul 9 2004, 08:57 AM Travis Neff I beat the hell out of mine with a drift and a 3lb... Jul 9 2004, 09:04 AM rhodyguy soak the pins well and let the penetrent work. ify... Jul 9 2004, 09:16 AM
|
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 4th July 2025 - 02:56 AM |
Invision Power Board
v9.1.4 © 2025 IPS, Inc.