 New brake pads on used rotors, What is the procedure for bedding? |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| ThePaintedMan |
 Jul 9 2013, 07:30 AM
Post
#1
|
|
Advanced Member  Group: Members Posts: 3,887 Joined: 6-September 11 From: St. Petersburg, FL Member No.: 13,527 Region Association: South East States 
 |
I guess this one's probably best for Eric, but I'm curious what the consensus is on the topic, so feel free to chime in. If one were to install a different compound of pads on an existing rotor, is there anything that needs to be done so that they will bed correctly? The rotors are in good shape and in my opinion aren't in need of turning, but when you install a different compound of pad, isn't there a difference in the chemicals that are transferred to the rotor? Is there a way to clean a rotor so that any old residue is removed and the new pads will transfer that initial layer of chemical material to the rotors to allow them to be properly bedded?
I've seen some guys put better pads on at the track before a DE, but use the same rotors. Is this a no-no? |
   |
 
|
  |
Replies
| ThePaintedMan |
Jul 9 2013, 11:39 AM
Post
#2
|
|
Advanced Member Group: Members Posts: 3,887 Joined: 6-September 11 From: St. Petersburg, FL Member No.: 13,527 Region Association: South East States
|
Sweet! So basically the new pads will remove any of the old residue when they are bedded appropriately. Good to know.
|
|
|
|
Posts in this topic
ThePaintedMan New brake pads on used rotors Jul 9 2013, 07:30 AM
pcar916 As long as they're truly flat, I'll rough ... Jul 9 2013, 09:26 AM Eric_Shea Just follow the bedding procedure. Jul 9 2013, 10:22 AM Cap'n Krusty Back when these cars were manufactured, the rotors... Jul 9 2013, 11:44 AM
Racer Chris The rotors should be scuffed to remove any of the ... Jul 9 2013, 12:00 PM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 4th July 2025 - 09:51 PM |
Invision Power Board
v9.1.4 © 2025 IPS, Inc.