 1.8--->2.0 Big Bore vs. stock 2.0, Cheeper to build a Big Bore from a 1.8? |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| thomasotten |
 Jul 9 2004, 09:36 AM
Post
#1
|
|
Senior Member  Group: Members Posts: 1,565 Joined: 16-November 03 From: San Antonio, Texas Member No.: 1,349  |
I need some advise as to which direction to take my project. I have a 1.8 engine that is already out of my car. It could use a rebuild. I was wondering, for a street car with miild performance increases desired, what are the pros and cons of rebuilding a 1.8 engine to a big bore 2.0, as opposed to just buying a stock 2.0L and rebuilding that? Would I come out about the same, cost and performance wise? Either system will have 2.0L heat exhangers/exhaust.
|
   |
 
|
  |
Replies
| Cap'n Krusty |
Jul 16 2004, 05:48 PM
Post
#2
|
|
Cap'n Krusty Group: Members Posts: 10,794 Joined: 24-June 04 From: Santa Maria, CA Member No.: 2,246 Region Association: Central California |
Ya might want to consider using a 2 litre crank and rods with your 96s (different from the 1.7/1.8 96s, BTW, with a different pin location). Lot of 'em out there, being they came in all the busses from '76-'79. The Cap'n
|
|
|
|
Posts in this topic
thomasotten 1.8--->2.0 Big Bore vs. stock 2.0 Jul 9 2004, 09:36 AM
seanery Webcam $158
Lifters $140
96mm Pistons/Cy... Jul 9 2004, 09:49 AM tat2dphreak the cost would be similar... you would have to fac... Jul 9 2004, 09:55 AM anthony Since labor and machining costs would be the same ... Jul 9 2004, 10:56 AM thomasotten So does the 1.8/1.7 case need to be machined to ac... Jul 15 2004, 08:56 AM tat2dphreak ... Jul 15 2004, 01:30 PM newdeal2 I have yet to get an answer on the cost but I have... Jul 15 2004, 02:02 PM Dave_Darling The 2.0 heads, in stock form, make better power th... Jul 15 2004, 03:09 PM tat2dphreak you should at least check the align bore... it doe... Jul 15 2004, 03:22 PM thomasotten Is aircooled.net's upgraded oil pump the same ... Jul 15 2004, 03:50 PM tat2dphreak I don't know if they are EXACTLY the same... b... Jul 16 2004, 01:16 PM p914 ... Jul 16 2004, 01:40 PM
|
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 1st July 2025 - 04:08 AM |
Invision Power Board
v9.1.4 © 2025 IPS, Inc.