 Sail panel/targa chrome trim, Any alternatives to drilling holes for clips ? |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| Fmiller01 |
 Oct 20 2013, 07:40 AM
Post
#1
|
|
Newbie  Group: Members Posts: 2 Joined: 20-October 13 From: Columbus, OH Member No.: 16,540 Region Association: None  |
Considering the havoc that was created by to the original holes in the sail panel for the chrome trim, I'd really rather not go that route again, but I do like the looks of the vinyl and chrome trim.. Are there any alternatives out there?
|
   |
 
|
  |
Replies
| larss |
Oct 21 2013, 12:21 PM
Post
#2
|
|
Member Group: Members Posts: 434 Joined: 10-September 09 From: Sweden Member No.: 10,787 Region Association: Scandinavia |
I had the same fear to, did not want to drill the holes for the thin horizontal chrome trim.
I bent the trim slightly convex so that the ends would not touch the panel only the middle would . Then i bent in and fixed the trim with one pop rivet (2,5mm in dia) at each end only, one rivet vent under the rear trim and the other inside the door post. Thanks to the trim being convex the rest of it keeps close to the panel without any tape. /Lars S |
|
|
|
Posts in this topic
Fmiller01 Sail panel/targa chrome trim Oct 20 2013, 07:40 AM
JawjaPorsche
Considering the havoc that was created by to the ... Oct 20 2013, 10:59 AM
Steve
Considering the havoc that was created by to the... Oct 21 2013, 08:56 AM rick 918-S
[quote name='JawjaPorsche' post='1943608' date='O... Oct 21 2013, 09:13 AM r_towle
Considering the havoc that was created by to the ... Oct 20 2013, 04:09 PM ericoneal I did this and it worked out really well..
Doubl... Oct 21 2013, 11:04 AM larryM excellent solution!
i might do that
I had t... Nov 7 2013, 03:43 PM Pat Garvey One the early (pre-74) cars there was a piece of r... Nov 7 2013, 08:16 PM anderssj I'm always a little afraid of using RTV, silic... Nov 8 2013, 05:12 PM boxstr As long as you are starting with a relatively clea... Nov 8 2013, 08:35 PM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 2nd April 2026 - 03:03 PM |
Invision Power Board
v9.1.4 © 2026 IPS, Inc.