 Sail panel/targa chrome trim, Any alternatives to drilling holes for clips ? |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| Fmiller01 |
 Oct 20 2013, 07:40 AM
Post
#1
|
|
Newbie  Group: Members Posts: 2 Joined: 20-October 13 From: Columbus, OH Member No.: 16,540 Region Association: None  |
Considering the havoc that was created by to the original holes in the sail panel for the chrome trim, I'd really rather not go that route again, but I do like the looks of the vinyl and chrome trim.. Are there any alternatives out there?
|
   |
 
|
  |
Replies
| boxstr |
Nov 8 2013, 08:35 PM
Post
#2
|
|
MEMBER:PACIFIC NORTHWEST REGION Group: Members Posts: 7,522 Joined: 25-December 02 From: OREGON Member No.: 12 Region Association: Pacific Northwest |
As long as you are starting with a relatively clean area, paint the holes after drilling them, I seriously doubt you will ends up with the havoc that years of rain and neglect reaped onto your sail panels.
Paint with a rust preventative or "Rust Bullet" and you will be fine. Craig at CAMP |
|
|
|
Posts in this topic
Fmiller01 Sail panel/targa chrome trim Oct 20 2013, 07:40 AM
JawjaPorsche
Considering the havoc that was created by to the ... Oct 20 2013, 10:59 AM
Steve
Considering the havoc that was created by to the... Oct 21 2013, 08:56 AM rick 918-S
[quote name='JawjaPorsche' post='1943608' date='O... Oct 21 2013, 09:13 AM r_towle
Considering the havoc that was created by to the ... Oct 20 2013, 04:09 PM ericoneal I did this and it worked out really well..
Doubl... Oct 21 2013, 11:04 AM larss I had the same fear to, did not want to drill the ... Oct 21 2013, 12:21 PM larryM excellent solution!
i might do that
I had t... Nov 7 2013, 03:43 PM Pat Garvey One the early (pre-74) cars there was a piece of r... Nov 7 2013, 08:16 PM anderssj I'm always a little afraid of using RTV, silic... Nov 8 2013, 05:12 PM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 2nd April 2026 - 01:13 PM |
Invision Power Board
v9.1.4 © 2026 IPS, Inc.