 Steering column |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| 914itis |
 Jan 11 2014, 06:26 PM
Post
#1
|
|
Advanced Member  Group: Members Posts: 2,892 Joined: 9-October 10 From: New York City Member No.: 12,256 Region Association: North East States  |
I am rebuilding a 70 (early) steering column and seems to have an issue putting the signal arm back in.
The arm is mounted by 4 screws, as shown in #5, when I install the arm, if the screws are tight, the signal lever will not go up and down freely. I tried everything... what am I doing wrong? I look at the diagram and it seems to be fine. Attached image(s) 
|
   |
 
|
  |
Replies
| r_towle |
Jan 12 2014, 10:47 AM
Post
#2
|
|
Custom Member Group: Members Posts: 24,591 Joined: 9-January 03 From: Taxachusetts Member No.: 124 Region Association: North East States 
|
It's inside assembly number 2 in the diagram
|
|
|
|
Posts in this topic
914itis Steering column Jan 11 2014, 06:26 PM
r_towle I recall this issue, not sure which car.
Seems the... Jan 12 2014, 09:45 AM
914itis
I recall this issue, not sure which car.
Seems th... Jan 12 2014, 10:44 AM r_towle Look at the assembly.
It's two boards with spa... Jan 12 2014, 10:46 AM 914itis # 6 has 4 legs / tabs when I attempted to move the... Jan 12 2014, 11:04 AM 914itis I got it!
after looking at # 6 over and ove... Jan 12 2014, 12:00 PM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 10th June 2024 - 06:30 AM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.