 Impeller Removal, turn turn turn |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| jandro62 |
 Aug 3 2004, 12:42 PM
Post
#1
|
|
Member  Group: Members Posts: 104 Joined: 4-June 04 From: Texas Member No.: 2,156  |
So I've got the motor & tranny on a dolly in my driveway. I've removed the engine tin and have gotten the front half of the impeller housing off. How do I remove those 12-point bolts without turning the motor? I remember reading somewhere that jamming a screwdriver between the fanblades is a serious no-no.
Also, I'm about to split the transmission off the rear... is that straightforward? |
   |
 
|
  |
Replies
| Cap'n Krusty |
Aug 3 2004, 01:57 PM
Post
#2
|
|
Cap'n Krusty Group: Members Posts: 10,794 Joined: 24-June 04 From: Santa Maria, CA Member No.: 2,246 Region Association: Central California |
Unless you want to clean the inside of the blower housing, you don't need to take it apart. Just remove the 3 bolts in the center of the fan, pull it out, remove the 4 nuts that hold the housing to the case, and the one holding the oil cooler bracket to the housing, and pull it off. Oh, don't forget the thermostat wire ............... HTH, The Cap'n
|
|
|
|
Posts in this topic
jandro62 Impeller Removal Aug 3 2004, 12:42 PM
synthesisdv I'm not totally clear about the bolts you are ... Aug 3 2004, 12:51 PM jandro62 I'm swapping the housing and other gear over t... Aug 3 2004, 12:59 PM Mueller hold the flywheel.......there are a few holes in t... Aug 3 2004, 01:14 PM
Dave_Darling I have used a screwdriver through the fan blades. ... Aug 3 2004, 03:30 PM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 3rd June 2024 - 05:40 AM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.