 Pertronix Ignitor II and Flame Thrower Coil |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| Alfieg23 |
 Mar 14 2014, 10:29 PM
Post
#1
|
|
Newbie  Group: Members Posts: 44 Joined: 7-January 14 From: Miramar, Florida Member No.: 16,854 Region Association: South East States  |
I just completed installing the Ignitor II and Flame Thrower coil. When I went to start the car, the engine cranks but does not start. I had already installed new plugs, wires, distributor cap and rotor. What should I do to troubleshoot the problem? Thanks.
|
   |
 
|
  |
Replies
| stugray |
Mar 15 2014, 04:14 PM
Post
#2
|
|
Advanced Member Group: Members Posts: 3,825 Joined: 17-September 09 From: Longmont, CO Member No.: 10,819 Region Association: None |
I just installed an electronic ignition to replace the points.
First mistake was hooking up the wires wrong even after reading the instructions. The pertronix wires hook to the coil +(IGN) and the coil -. The module grounds through the distributor. I hooked mine between the coil - and chassis GND like the points would. This was incorrect. |
|
|
|
Posts in this topic
Alfieg23 Pertronix Ignitor II and Flame Thrower Coil Mar 14 2014, 10:29 PM
Alfieg23 I had removed the distributor to install the Ignit... Mar 15 2014, 05:57 AM SLITS 1st question is, "Do you have spark at all?... Mar 15 2014, 06:00 AM Java2570 I would definitely make sure you have all your con... Mar 15 2014, 07:30 AM luskesq No need to change ignition wires. Make sure the m... Mar 15 2014, 05:15 PM Java2570 I just looked this up on the Pertronix website....... Mar 15 2014, 09:29 PM Alfieg23 Thanks, everyone. I checked and had no spark. I th... Mar 15 2014, 10:46 PM
SLITS
Thanks, everyone. I checked and had no spark. I t... Mar 16 2014, 08:40 AM stugray At first I was thinking that you could not hurt th... Mar 16 2014, 12:54 AM Alfieg23
At first I was thinking that you could not hurt t... Mar 16 2014, 10:31 AM Alfieg23 The Ignitor II module I received is part # 91847V,... Mar 16 2014, 10:32 AM stugray That unit states "Built in reverse polarity a... Mar 16 2014, 01:27 PM rhodyguy i've burned up both compufire and mallory modu... Mar 16 2014, 02:06 PM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 16th June 2024 - 02:01 PM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.