 Pertronix Ignitor II and Flame Thrower Coil |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| Alfieg23 |
 Mar 14 2014, 10:29 PM
Post
#1
|
|
Newbie  Group: Members Posts: 44 Joined: 7-January 14 From: Miramar, Florida Member No.: 16,854 Region Association: South East States  |
I just completed installing the Ignitor II and Flame Thrower coil. When I went to start the car, the engine cranks but does not start. I had already installed new plugs, wires, distributor cap and rotor. What should I do to troubleshoot the problem? Thanks.
|
   |
 
|
  |
Replies
| Alfieg23 |
Mar 15 2014, 10:46 PM
Post
#2
|
|
Newbie Group: Members Posts: 44 Joined: 7-January 14 From: Miramar, Florida Member No.: 16,854 Region Association: South East States |
Thanks, everyone. I checked and had no spark. I think I may have blown the Ignitor II module. I will re-install the points and condenser tomorrow and check for spark. As for the plug wires, I installed Magnecor KV85 wires, which are supposed to be spiral wound.
If I did blow out the Ignitor II module, could there be any additional damage to the electrical system? |
|
|
|
Posts in this topic
Alfieg23 Pertronix Ignitor II and Flame Thrower Coil Mar 14 2014, 10:29 PM
Alfieg23 I had removed the distributor to install the Ignit... Mar 15 2014, 05:57 AM SLITS 1st question is, "Do you have spark at all?... Mar 15 2014, 06:00 AM Java2570 I would definitely make sure you have all your con... Mar 15 2014, 07:30 AM stugray I just installed an electronic ignition to replace... Mar 15 2014, 04:14 PM luskesq No need to change ignition wires. Make sure the m... Mar 15 2014, 05:15 PM Java2570 I just looked this up on the Pertronix website....... Mar 15 2014, 09:29 PM
SLITS
Thanks, everyone. I checked and had no spark. I t... Mar 16 2014, 08:40 AM stugray At first I was thinking that you could not hurt th... Mar 16 2014, 12:54 AM Alfieg23
At first I was thinking that you could not hurt t... Mar 16 2014, 10:31 AM Alfieg23 The Ignitor II module I received is part # 91847V,... Mar 16 2014, 10:32 AM stugray That unit states "Built in reverse polarity a... Mar 16 2014, 01:27 PM rhodyguy i've burned up both compufire and mallory modu... Mar 16 2014, 02:06 PM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 16th June 2024 - 02:12 PM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.