Home  |  Forums  |  914 Info  |  Blogs
 
914World.com - The fastest growing online 914 community!
 
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG. This site is not affiliated with Porsche in any way.
Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners.
 

Welcome Guest ( Log In | Register )

> wiper switch help needed, how to wire in a toggle switch?
mobymutt
post May 12 2014, 04:14 PM
Post #1


Senior Member
***

Group: Members
Posts: 553
Joined: 16-December 13
From: Kingston, Ontario, Canada
Member No.: 16,770
Region Association: Canada



I am attempting to diagnose my non-working wipers by testing the switch directly.

So far I have removed the steering wheel and removed the 4 screws inside. The stuff in the column is 'loose' now, but I can't actually remove anything, only pull it out by about 1/2" or so. Is there a trick? I am afraid of breaking something if I pull too hard.
User is offlineProfile CardPM
Go to the top of the page
+Quote Post
 
Reply to this topicStart new topic
Replies
ripper911
post May 18 2014, 07:06 AM
Post #2


corde pulsum tangite
****

Group: Members
Posts: 2,920
Joined: 25-April 10
From: Powder Springs, GA
Member No.: 11,654
Region Association: South East States



I used the testing procedure in tech tips 700 to determine that I have a bad switch. I think we just hooked into the slow wiper speed wire on one side of the toggle switch and a spade on the fuse panel with switched power for the other side, but it's been a few years since I did it. It still works.
User is offlineProfile CardPM
Go to the top of the page
+Quote Post

Posts in this topic


Reply to this topicStart new topic
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:

 



- Lo-Fi Version Time is now: 9th May 2025 - 01:38 PM