 what to use?, just oil or sealant or nothing? |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| jacksun |
 Jul 7 2014, 06:10 PM
Post
#1
|
|
Member  Group: Members Posts: 236 Joined: 8-August 13 From: mi Member No.: 16,224 Region Association: Upper MidWest  |
hi,
this question is about the push rod tube seals and what to use if anything? I have read many opinions... still not sure if I use a sealant like permatex high temp thread sealant,,,,,,,,,, where would I place it......A or B or not ? the seals in the image are old and not replaced yet thank you r  |
   |
 
|
  |
Replies
| stugray |
Jul 8 2014, 07:55 AM
Post
#2
|
|
Advanced Member Group: Members Posts: 3,825 Joined: 17-September 09 From: Longmont, CO Member No.: 10,819 Region Association: None |
The next question should be:
How do these spring thingys go in? You DO have the tube retention springs right? When you put the rockers back in, the slot on the clamp faces down. The springs can go in after the pushrods, but before tightening the rockers down all the way down. |
|
|
|
Posts in this topic
jacksun what to use? Jul 7 2014, 06:10 PM
StratPlayer I just put a little oil on mine on a fresh rebuild... Jul 7 2014, 06:49 PM stugray I use loctite 565 teflon thread sealant (NON-harde... Jul 7 2014, 07:17 PM jacksun tks for the replies..
the thread on "paint... Jul 8 2014, 05:52 AM stugray Both sides. Just coat the oring.
With that stuff, ... Jul 8 2014, 07:17 AM jacksun thank you Jul 8 2014, 07:37 AM Dave_Darling The lower part of the spring should rest on the sh... Jul 8 2014, 11:53 AM jacksun thank you for the info..
I only removed one side ... Jul 8 2014, 04:29 PM Elliot Cannon These guys built my engine and this is what they u... Jul 8 2014, 04:39 PM Dave_Darling So they've been doing it wrong for 30 years...... Jul 8 2014, 10:56 PM
Elliot Cannon
So they've been doing it wrong for 30 years..... Jul 9 2014, 12:13 AM ClayPerrine I use a little plain, ordinary wheel bearing greas... Jul 9 2014, 05:50 AM 9146986 I'll 2nd the Loctite 565. It's a tip I go... Jul 9 2014, 07:15 AM Jake Raby I've done it many ways. No matter what method ... Jul 9 2014, 07:37 AM Mark Henry I now use DOW Corning Molykote 55 seems to work go... Jul 9 2014, 07:58 AM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 2nd April 2026 - 02:48 PM |
Invision Power Board
v9.1.4 © 2026 IPS, Inc.