914 flywheel noise? |
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
914 flywheel noise? |
Socal70 |
Aug 4 2014, 04:51 PM
Post
#1
|
Newbie Group: Members Posts: 4 Joined: 4-August 14 From: Vista, ca Member No.: 17,731 Region Association: None |
So I just pulled my transmission out of my 70 (side shifter with a 1.8), I replaced my flywheel due to work teeth, got the car back together and the car sounded great for 5 minutes and then developed a light grinding noise. It's coming from the transmission area and most noticeable when it's idling. Anyone had similar issues?
|
Cap'n Krusty |
Aug 6 2014, 10:56 AM
Post
#2
|
Cap'n Krusty Group: Members Posts: 10,794 Joined: 24-June 04 From: Santa Maria, CA Member No.: 2,246 Region Association: Central California |
I thought the conversation was moving in the right direction, so I simply made a quick mechanical point. Here we go with a more complete answer. No, you don't really need to set the end play after changing the flywheel, unless it's a knockoff. The crank and case are the primary determining factor, and the OE flywheels are pretty much right on the money. You should, however, ALWAYS check it. The noise described in the OP isn't likely to be a result of improper end play. Onward: While the release bearing can make noise, that noise is most common when the clutch pedal is depressed and the bearing is under load. If the ball cup in the release arm has become badly worn, or if the flywheel has been cut too far, the arm can touch the clutch cover and a grinding noise occurs. If the pilot bearing fails, significant noise will occur when the clutch pedal is depressed. It will rapidly deteriorate and shifting will become difficult as the mainshaft will be pretty much connected to the crankshaft. If the starter "hangs up", there could be more than one cause, and it'll both make noise and remove teeth from the ring gear. Starters get old, dry, and non functional in several ways. It works, so we know the bendix shoots out and turns the flywheel. However, it may not fully retract in a timely manner. Bad spring? Dry shaft? Can't tell, maybe even with the starter out of the car. Another cause may be a faulty ignition switch or feedback into the "50" circuit. Often the hangup will remain even when the engine is revved, but the noise of the engine drowns out the sound. This usually leads to a blown up starter. I've even seen the starter body shatter.
If the o-ring in the flywheel fails or is deleted, you're gonna have an oil leak, which will quickly coat the clutch disc, the flywheel, and the pressure plate with oil, but there'll be no noise connected with that problem. There you are. The Cap'n |
Lo-Fi Version | Time is now: 8th June 2024 - 01:56 AM |
All rights reserved 914World.com © since 2002 |
914World.com is the fastest growing online 914 community! We have it all, classifieds, events, forums, vendors, parts, autocross, racing, technical articles, events calendar, newsletter, restoration, gallery, archives, history and more for your Porsche 914 ... |