 Is there a better solution to stainless steel oil lines? |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| patssle |
 Aug 13 2014, 07:51 PM
Post
#1
|
|
Senior Member  Group: Members Posts: 981 Joined: 28-August 09 From: Houston, TX Member No.: 10,741 Region Association: None  |
It's too late for me to switch on this /6 conversion but for future note. These hoses are a PITA to make - surely there is something easier and more flexible. I notice Aeroquip has Socketless non-SS hose but that is a kinda scary product as it does not use hose clamps.
 |
   |
 
|
  |
Replies
| patssle |
Aug 14 2014, 07:40 PM
Post
#2
|
|
Senior Member Group: Members Posts: 981 Joined: 28-August 09 From: Houston, TX Member No.: 10,741 Region Association: None |
Thanks Andy. And it's 100% secure? It just looks like a hose on a barb which is a little scary for an oil system. You ran the same hose underneath and directly to the engine output as well - with them right next to the exhaust heat?
|
|
|
|
Posts in this topic
patssle Is there a better solution to stainless steel oil lines? Aug 13 2014, 07:51 PM
messix you can have rubber oil lines made http://www.disc... Aug 13 2014, 07:56 PM Mike D. PushLok - USE HOSE CLAMPS Aug 13 2014, 08:07 PM 02loftsmoor try at truck shop they use cloth coverd oil line a... Aug 13 2014, 08:08 PM Dave_Darling I used non-covered hydraulic hose. Good for far m... Aug 14 2014, 08:41 AM SirAndy surely there is something easier and more flexible... Aug 14 2014, 01:42 PM
SirAndy And it's 100% secure?
:confused:
Operating ... Aug 14 2014, 07:47 PM patssle You know what I discovered....garden hose and AN f... Aug 14 2014, 07:59 PM Mike Bellis I want Tangerine to offer some mandrel bent 3/4... Aug 14 2014, 09:56 PM Vacca Rabite If you use a proper hose cutter instead of tape an... Aug 15 2014, 06:28 AM Harpo I use a cut off wheel on my die grinder after I wr... Aug 15 2014, 06:53 AM Cap'n Krusty Push Loc is the way to go. I've used it for y... Aug 15 2014, 09:17 AM Dave_Darling Here's some pics of what I used:
http://www.9... Aug 15 2014, 09:31 AM Phoenix-MN I found this tip at Earl's the last time I ass... Aug 15 2014, 09:40 AM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 8th June 2024 - 05:28 PM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.