 Cleaning Heat Exchangers |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| BenNC |
 May 2 2003, 08:53 AM
Post
#1
|
|
Member  Group: Members Posts: 140 Joined: 7-February 03 From: Cary, NC Member No.: 267  |
Any thoughts on cleaning the insides of heat exchangers.
I acquired a used set, cleaned up the outsides, and hooked them up. Last night I put the muffler on and let the car run for a few minutes (a recent development that I am quite thrilled about). A few minutes later it started smoking like a chimney. A quick peek underneath found that the smoke was pouring out of the heat exchangers. At least it got all of the mosquitoes out of the garage. Thanks |
   |
 
|
  |
Replies
| URY914 |
May 2 2003, 09:29 AM
Post
#2
|
|
I built the lightest 914 in the history of mankind. Group: Members Posts: 127,511 Joined: 3-February 03 From: Jacksonville, FL Member No.: 222 Region Association: None |
What did you use to clean them with?
|
|
|
|
Posts in this topic
BenNC Cleaning Heat Exchangers May 2 2003, 08:53 AM
need4speed Get em powder coated. That'll clean em up. T... May 2 2003, 09:37 AM BenNC I used a combination of brake cleaner and elbow gr... May 2 2003, 11:03 AM Lawrence914-6 I let mine just burn off, but I suppose you could ... May 2 2003, 11:13 AM BenNC That sounds like fun, but I probably should make s... May 2 2003, 11:23 AM tryan simple green is good for baked on oil residue. lay... May 2 2003, 11:32 AM Brad Roberts Easy off oven cleaner...
B May 2 2003, 12:22 PM ThinAir914 Castrol SuperClean. I've never seen anything ... May 2 2003, 12:45 PM Mark Henry Ummmmm! lets see...
Get them hot tanked at a ... May 2 2003, 01:37 PM BenNC Ignorant question.
What is "hot tanked" and how m... May 2 2003, 02:02 PM Dave_Darling "Hot tanking" is the process of taking a part and ... May 2 2003, 02:48 PM need4speed I remember a guy on another mailing list a few mon... May 2 2003, 03:23 PM
Mark Henry A good shop should know if something is mag or alu... May 2 2003, 08:05 PM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 14th July 2025 - 03:09 AM |
Invision Power Board
v9.1.4 © 2025 IPS, Inc.