![]() |
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
![]() |
DavidSweden |
![]()
Post
#1
|
Member ![]() ![]() Group: Members Posts: 481 Joined: 8-June 14 From: Sweden Member No.: 17,452 Region Association: Scandinavia ![]() |
I am currently rebuilding engine. In order not to tire everyone with a lot of newbie questions I have been searching the forum (thanks for the tip Cap“n).
There has been a lot of debate about using or not using head gaskets. Is this the VW tech bulletin which has been referred to in some of the post recommending not to use the head gaskets? VW Tech bulletin head gasket David |
![]() ![]() |
dknechtly |
![]()
Post
#2
|
Yellow 914 ![]() ![]() Group: Members Posts: 68 Joined: 11-April 03 From: Wylie, TX Member No.: 560 Region Association: None ![]() |
I usually do not use head gaskets. I have the heads fly cut and also lap them to the cylinder. However on my last build, I had trouble lapping and as I looked closer, a rim around the combustion chamber on the head was butting against a rim around the cylinder wall. This would keep the cylinder from sealing tight with the head. In this case, a head gasket gave me the clearance I needed.
|
![]() ![]() |
![]() |
Lo-Fi Version | Time is now: 1st July 2025 - 10:02 PM |
All rights reserved 914World.com © since 2002 |
914World.com is the fastest growing online 914 community! We have it all, classifieds, events, forums, vendors, parts, autocross, racing, technical articles, events calendar, newsletter, restoration, gallery, archives, history and more for your Porsche 914 ... |