 Bushings for shift rod coupling, How to install |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| jack20 |
 Nov 21 2014, 09:14 AM
Post
#1
|
|
Member  Group: Members Posts: 422 Joined: 7-November 14 From: Granite Bay, CA Member No.: 18,099 Region Association: Northern California 
 |
Ordered all new shift linkage bushings. The bushings for the coupling near firewall have me stumped. Does the rod need to be pressed out to install the bushings? Or...do I remove the old bushing and slip the new ones in from the outside?
|
   |
 
|
  |
Replies
| stugray |
Nov 21 2014, 09:36 AM
Post
#2
|
|
Advanced Member Group: Members Posts: 3,825 Joined: 17-September 09 From: Longmont, CO Member No.: 10,819 Region Association: None |
The rod has to come out.
If it is a tail shift, I believe the rod can be pulled out the rear. If it is a side shift, the bar cannot be removed completely with the engine bar in the way. FOr that disconnect the bar on both ends and push it forward into the tunnel while you replace the bushing. Some have luck heating the bushing in bioling water and popping it in. That didnt work for me for whhatever reason so I used a carriage bolt and some large washers and sandwiched the bushing in place. That way you just tighten a nut and it pushed the bushing right in. |
|
|
|
Posts in this topic
jack20 Bushings for shift rod coupling Nov 21 2014, 09:14 AM
jack20
The rod has to come out.
If it is a tail shift, ... Nov 21 2014, 09:41 AM
Hank914
The rod has to come out.
If it is a tail shift, ... Nov 21 2014, 10:36 AM SLITS Firewall bushing ... remove rod, remove old one fr... Nov 21 2014, 09:38 AM Cap'n Krusty Yes.
The Cap'n Nov 21 2014, 09:51 AM jack20
Yes.
The Cap'n
No danger of bending the wel... Nov 21 2014, 09:59 AM AvalonFal Use a piece of pipe or tubing that will fit over t... Nov 21 2014, 10:15 AM jack20
Use a piece of pipe or tubing that will fit over ... Nov 21 2014, 10:20 AM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 8th November 2025 - 01:46 AM |
Invision Power Board
v9.1.4 © 2025 IPS, Inc.