 part identity help, strut assemblies |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| rhodyguy |
 Jan 5 2015, 04:02 PM
Post
#1
|
|
Chimp Sanctuary NW. Check it out.  Group: Members Posts: 22,098 Joined: 2-March 03 From: Orion's Bell. The BELL! Member No.: 378 Region Association: Galt's Gulch  |
had these for a while. no part # to be seen. 3" caliper spacing. any clues as to their application? was told from a 911. thanks.
k Attached thumbnail(s)   
|
   |
 
|
  |
Replies
| Mark Henry |
Jan 5 2015, 05:06 PM
Post
#2
|
|
that's what I do! Group: Members Posts: 20,065 Joined: 27-December 02 From: Port Hope, Ontario Member No.: 26 Region Association: Canada |
The struts look a lot like 911T struts, same as 914/6, good for a 5 bolt conversion using the alfa calipers.
There should be a 914 xxx xxx part number even if off a 911, should be right above the brake line tab. |
|
|
|
Posts in this topic
rhodyguy part identity help Jan 5 2015, 04:02 PM
rhodyguy these too. 3 1/2' bolt spacing, '280' ... Jan 5 2015, 04:14 PM rhodyguy that helped mark, found some #s. one has V 38 976 ... Jan 5 2015, 05:37 PM Eric_Shea Struts are early pinch bolt style 911 struts. They... Jan 5 2015, 06:04 PM rhodyguy very good. the spacer measurement is 7mm. here... Jan 5 2015, 06:22 PM
Eric_Shea Early multi-colored one. Gold spray paint on the ... Jan 5 2015, 06:55 PM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 16th June 2024 - 07:03 PM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.