 SS Fuel Line Replacement |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| jks1981 |
 Oct 23 2012, 07:54 AM
Post
#1
|
|
Newbie  Group: Members Posts: 5 Joined: 16-April 12 From: London, Ontario Member No.: 14,389 Region Association: Canada  |
Hello,
I recently bought my first 914, and within a couple of weeks, gas was pouring out the bottom of it. The previous owner had rubber fuel hose running from the gas tank to the fuel pump in the engine compartment (carbed car). This line had cracked where it exited the firewall under the enginer compartment. So I am going to replace the tunnel line with stainless, keeping in mind this car is now carbed, does it matter if I use 9.5 or 8mm? Also, where the fuel line exits under the engine compartment, is it best to just connect up some hose to run into the compartment, or is there a better way? It seems the lines are pretty exposed there. Thanks! James |
   |
 
|
  |
Replies
| ChrisFoley |
Jun 24 2015, 06:24 AM
Post
#2
|
|
I am Tangerine Racing Group: Members Posts: 7,986 Joined: 29-January 03 From: Bolton, CT Member No.: 209 Region Association: None 
|
Those are OD measurements.
It would be better to use 9.5mm for the supply side. |
|
|
|
Posts in this topic
jks1981 SS Fuel Line Replacement Oct 23 2012, 07:54 AM
John Jentz Look in the Member Vendors forum, Rotary'914 a... Oct 23 2012, 08:20 AM ConeDodger It doesn't matter. Replace all the hose with m... Oct 23 2012, 08:46 AM Racer Chris
... does it matter if I use 9.5 or 8mm? ...
I b... Oct 23 2012, 10:59 AM bperry CFR SS lines
Rotary14 SS lines
DIY SS lines
The ... Oct 23 2012, 01:33 PM worn
Hello,
I recently bought my first 914, and within... Oct 23 2012, 02:15 PM
struckn
Hello,
I recently bought my first 914, and within... Oct 23 2012, 05:28 PM scotty b I just today replaced a customers lines with a CFR... Oct 23 2012, 05:36 PM jks1981 Thanks for all the replies!
I think I will go ... Oct 23 2012, 09:24 PM maddin Ok,don't want to start a new post.
We're ... Jun 23 2015, 05:58 PM maddin
Those are OD measurements.
It would be better to ... Jun 24 2015, 02:39 PM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 11th May 2025 - 10:52 AM |
Invision Power Board
v9.1.4 © 2025 IPS, Inc.