crankfire parts, for /4 or /6 or even V8 :), for you DIY'ers using EDIS system Options

[Mueller]

here is a comparison of the parts i took off of a car at the wreckers (ford escort) and the parts I found at NAPA auto parts


the bigger diameter wheel is a "wrecker" part and the sensor @ the 3:00 position is from the same car

smaller wheel and sensor just past the 1:00 position is are the new parts

obviously, the wheel will have to be modified to fit the /4 and a bracket will be needed for the sensor.

When I get back in a week from vacation, I will modify and mount the trigger wheel and make a bracket for the sensor....if there is any interest, I'll make a few extras for a small fee....currently I know I need to make at least 2 more, one for James Montebello and one for Jerry in Pleasanton (sorry cannot remeber your last name right now, (IMG:style_emoticons/default/wacko.gif) )

NAPA part numbers are:

CSS304 wheel
CSS411 sensor

now for the rest, you are on your own, hahahaha

[3liter914-6]

close up of the wheel I got. It is much bigger than the pully, but I can get another if I need. Probably a 4cyl one would be smaller.

Based on the picture, the 4-cyl wheel is smaller. My SC pulley is 131mm or ~5.15 inches, the 4-cyl trigger wheel is around 5.7". If you decide to go that way, it's around $20 at the dealer for a brand new one. Probably just as cheap and easier than scrounging at a pick-n-pull. You'll have to check to see if that extra 1/2" is going to foul on the fan housing or on the engine mount if you mount the wheel to the face of the pulley.