 Rocker Fasteners |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| kupcar |
 Aug 16 2015, 06:56 AM
Post
#1
|
|
Member  Group: Members Posts: 95 Joined: 14-February 13 From: Chicago Member No.: 15,528 Region Association: None  |
I'm getting ready to mount my rocker panels and I was wondering what is the proper fastening hardware to do the job. I can't seem to find any pictures. Is it a simple phillips machine screw from the top with a washer and nut from below? What about the bottom? Thanks.
|
   |
 
|
  |
Replies
| Cuda911 |
Aug 17 2015, 09:43 PM
Post
#2
|
|
Senior Member Group: Members Posts: 1,489 Joined: 20-May 14 From: Oceanside (N. San Diego County), CA Member No.: 17,376 Region Association: Southern California |
I recommend ditching the cheeseheads for hex heads, so that you can get a socket onto them. The cheesey's can get extremely difficult to get loose.
|
|
|
|
Posts in this topic
kupcar Rocker Fasteners Aug 16 2015, 06:56 AM
The Cabinetmaker They were riveted on the top. There are plenty of ... Aug 16 2015, 07:09 AM r_towle Black rivets are the OEM fastener.
I use stainless... Aug 16 2015, 07:28 AM
RobW
Black rivets are the OEM fastener.
I use stainles... Aug 16 2015, 07:34 AM
Tom_T
Black rivets are the OEM fastener.
I use stainles... Aug 16 2015, 12:02 PM Shadowfax I have an extra set of pop rivets from 914rubber. ... Aug 16 2015, 07:30 AM rgalla9146 Pictures of actual original hardware for reference... Aug 16 2015, 08:55 AM 914Next rgalla9146,
The topic of rivets seems to have bee... Aug 18 2015, 04:40 AM kupcar Fellas, Thanks for all the help. This board and it... Aug 17 2015, 09:03 PM euro911 The PO of my car installed aftermarket fiberglass ... Aug 18 2015, 01:04 AM JawjaPorsche I agree about sheet metal screws. You can remove ... Aug 18 2015, 05:59 AM era vulgaris
I agree about sheet metal screws.
I used stain... Dec 9 2015, 09:36 AM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 12th June 2024 - 05:41 PM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.