 Clutch lever arm - how's this look |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| Amphicar770 |
 Apr 30 2016, 08:11 PM
Post
#1
|
|
Senior Member  Group: Members Posts: 1,229 Joined: 20-April 10 From: PA, USA Member No.: 11,639 Region Association: MidAtlantic Region 
 |
In addition to the one already there, I added a 2nd 1mm washer under the pivot ball.
With tranny mounted to engine, looks like about 1/2" on the engine side if throw out bearing is touching pressure plate. About an inch on the other side. Good or do I need another washer or thicker washer? Thx.  |
   |
 
|
  |
Replies
| iankarr |
Apr 30 2016, 10:31 PM
Post
#2
|
|
The wrencher formerly known as Cuddy_K Group: Members Posts: 2,595 Joined: 22-May 15 From: Heber City, UT Member No.: 18,749 Region Association: Intermountain Region
|
I believe that 1/2" guideline in the pelican write up is conservative. My car had about 3/4" of play with the cable off. And plenty of thread left to adjust with a few of those 1/4" spacers before the nuts. try mounting it up and see. Just leave the CV bolts for last when you're sure its all good.
|
 |
|
Posts in this topic
Amphicar770 Clutch lever arm - how's this look Apr 30 2016, 08:11 PM
dangrouche If 2mm was removed from the face of the flywheel, ... Apr 30 2016, 08:47 PM Amphicar770 Unfortunately, I do not know how much was taken of... Apr 30 2016, 08:51 PM
Amphicar770
I believe that 1/2" guideline in the pelican... May 1 2016, 06:31 AM r_towle Interesting, I never measured it that way.
For me... May 1 2016, 02:32 PM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 2nd April 2026 - 04:44 PM |
Invision Power Board
v9.1.4 © 2026 IPS, Inc.