Clutch Fork Throw Measurement, Need sanity check please |
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
Clutch Fork Throw Measurement, Need sanity check please |
Nozzle |
May 26 2016, 04:03 PM
Post
#1
|
Member Group: Members Posts: 158 Joined: 6-November 08 From: Lexington Park, Maryland Member No.: 9,725 Region Association: MidAtlantic Region |
Hey folks. So after just about two years I'm getting ready to finally reinstall the rebuilt engine and refreshed trans-axle. Before getting the drive-train back up in the car though I read in the Pelican clutch change tech article to check the clutch fork for adequate throw of 0.5 inch. Problem is I'm not sure where to measure from on the fork so I took these picks for a 914World QA check before going any further.
|
somd914 |
May 26 2016, 06:27 PM
Post
#2
|
Member Group: Members Posts: 1,171 Joined: 21-February 11 From: Southern Maryland Member No.: 12,741 Region Association: MidAtlantic Region |
So I know that in the second photo Nozzle's lunch fork arm is hitting the point of engagement. He is unsure with the rebuild whether the flywheel was replaced or machined, thus if machined an additional washer is likely needed on the pivot arm.
Thus Nozzle is trying to determine if a shim is necessary... |
Lo-Fi Version | Time is now: 2nd June 2024 - 01:16 PM |
All rights reserved 914World.com © since 2002 |
914World.com is the fastest growing online 914 community! We have it all, classifieds, events, forums, vendors, parts, autocross, racing, technical articles, events calendar, newsletter, restoration, gallery, archives, history and more for your Porsche 914 ... |