 Clutch Fork Throw Measurement, Need sanity check please |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| Nozzle |
 May 26 2016, 04:03 PM
Post
#1
|
|
Member  Group: Members Posts: 158 Joined: 6-November 08 From: Lexington Park, Maryland Member No.: 9,725 Region Association: MidAtlantic Region  |
Hey folks. So after just about two years I'm getting ready to finally reinstall the rebuilt engine and refreshed trans-axle. Before getting the drive-train back up in the car though I read in the Pelican clutch change tech article to check the clutch fork for adequate throw of 0.5 inch. Problem is I'm not sure where to measure from on the fork so I took these picks for a 914World QA check before going any further.
  |
   |
 
|
  |
Replies
| r_towle |
Jun 3 2016, 09:34 PM
Post
#2
|
|
Custom Member Group: Members Posts: 24,585 Joined: 9-January 03 From: Taxachusetts Member No.: 124 Region Association: North East States 
|
Looks adjusted properly
|
|
|
|
| Nozzle |
Jun 4 2016, 08:48 AM
Post
#3
|
|
Member Group: Members Posts: 158 Joined: 6-November 08 From: Lexington Park, Maryland Member No.: 9,725 Region Association: MidAtlantic Region |
QUOTE(r_towle @ Jun 3 2016, 11:34 PM)  Looks adjusted properly Many thanks Rich, just what I was hoping to hear. |
|
|
|
Posts in this topic
Nozzle Clutch Fork Throw Measurement May 26 2016, 04:03 PM
r_towle Not sure what the question is, but your clutch for... May 26 2016, 05:11 PM
tomrev With the fork pulled towards the rear of the car, ... May 26 2016, 05:55 PM somd914 So I know that in the second photo Nozzle's lu... May 26 2016, 06:27 PM r_towle The measurement is from the second position to ful... May 26 2016, 06:33 PM Nozzle
The measurement is from the second position to fu... May 26 2016, 07:57 PM r_towle Get a piece of angle iron.
Drill two holes in it t... May 26 2016, 07:59 PM JamesM
Hey folks. So after just about two years I'm... May 26 2016, 08:26 PM porschetub I didn't measure mine but yours appears ok,if ... May 27 2016, 08:53 PM Nozzle OP Update: Based on the suggestions above I planne... Jun 3 2016, 01:33 PM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 2nd June 2024 - 05:15 PM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.