 Handbrake cables sitting on my MSDS /6 headers, What can I do. Anyone else have this issue? |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| tornik550 |
 Aug 14 2016, 02:38 PM
Post
#1
|
|
Senior Member  Group: Members Posts: 1,248 Joined: 29-January 07 From: Ohio Member No.: 7,486 Region Association: None  |
I have a set of MSDS /6 headers and it appears that my handbrake cables sit right on the headers. I haven't started the engine yet cause they will obviously melt. Anyone else have this issue and if so what did you do?
|
   |
 
|
  |
Replies
| Krieger |
Aug 14 2016, 03:27 PM
Post
#2
|
|
Advanced Member Group: Members Posts: 4,803 Joined: 24-May 04 From: Santa Rosa CA Member No.: 2,104 Region Association: None 
|
I have them on my 3.0. The cable on the driver side does when I have the car lifted up and the trailing arm is down. It ends up touching the bottom of the headers. I have to make sure when the car is on the ground the cable is positioned over the header.
|
|
|
|
Posts in this topic
tornik550 Handbrake cables sitting on my MSDS /6 headers Aug 14 2016, 02:38 PM
Mark Henry Yep, once your 914 is on the ground it's no lo... Aug 14 2016, 04:14 PM tornik550 Thank you to everyone for the advice. I had neve... Aug 14 2016, 04:33 PM
Mark Henry Likely no, it's meant for close proximity and ... Aug 14 2016, 05:40 PM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 11th May 2025 - 11:45 AM |
Invision Power Board
v9.1.4 © 2025 IPS, Inc.