 Break In Question, Top end rebuild |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| jim_hoyland |
 Sep 24 2016, 03:53 PM
Post
#1
|
|
Get that VIN ?  Group: Members Posts: 9,314 Joined: 1-May 03 From: Sunset Beach, CA Member No.: 643 Region Association: Southern California 
 |
What the recommended steps for a break- in after a top end rebuild ? Oil, valves, etc
Replaced heads with new valves, springs, valve guides; new 96 mm pistons, and cylinders. 500 miles ? |
   |
 
|
  |
Replies
| jim_hoyland |
Sep 24 2016, 05:42 PM
Post
#2
|
|
Get that VIN ? Group: Members Posts: 9,314 Joined: 1-May 03 From: Sunset Beach, CA Member No.: 643 Region Association: Southern California
|
Interesting: i can do a series of short drives of 60 miles mostly flat but a couple of hills ( 405 then down the 73 and return
And / or a drive up Hwy 1 to San Simeon, about 190 miles, overnight stay then return to Huntington Beach I better load up on motor oil; looks like I can expect 2 changes ? |
|
|
|
Posts in this topic
jim_hoyland Break In Question Sep 24 2016, 03:53 PM
ConeDodger Probably most important for a top end rebuild woul... Sep 24 2016, 04:04 PM colingreene I dont go past 3/4 throttle and 3/4 max rpm and co... Sep 24 2016, 04:05 PM jim_hoyland Thanks. Just what I was looking for. Sounds like t... Sep 24 2016, 04:24 PM Rand It's interesting to see different takes. Some ... Sep 24 2016, 04:48 PM porschetub Don't over rev and lug the engine keep it on t... Sep 24 2016, 04:55 PM
earossi
Interesting: i can do a series of short drives of... Sep 24 2016, 07:07 PM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 2nd June 2024 - 01:02 PM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.