New member |
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
New member |
ricardo |
Nov 9 2016, 10:55 AM
Post
#1
|
Newbie Group: Members Posts: 47 Joined: 9-November 16 From: Lakeview, NY Member No.: 20,572 Region Association: North East States |
New to this site and not sure what I am doing or how to post a problem
|
ClayPerrine |
Nov 11 2016, 06:57 AM
Post
#2
|
Life's been good to me so far..... Group: Admin Posts: 15,520 Joined: 11-September 03 From: Hurst, TX. Member No.: 1,143 Region Association: NineFourteenerVille |
There should be a yellow wire with a female spade connector coming out of the engine harness on the same end as the 12 pin connector (relay board end).
Make sure that is connected to one of the two rear connectors on the 4 pin connector at the right rear of the relay board. If your pump does not run when you open the air flow meter flap, then your next step is to find the fuel pump, and use a test light to see if it is getting power when you open the air flow meter flap. Also, check to see if there is a heavy red wire from the double relay up to the positive post on the battery. If that is missing, nothing on your injection will work. |
ricardo |
Nov 11 2016, 07:27 AM
Post
#3
|
Newbie Group: Members Posts: 47 Joined: 9-November 16 From: Lakeview, NY Member No.: 20,572 Region Association: North East States |
There should be a yellow wire with a female spade connector coming out of the engine harness on the same end as the 12 pin connector (relay board end). Make sure that is connected to one of the two rear connectors on the 4 pin connector at the right rear of the relay board. If your pump does not run when you open the air flow meter flap, then your next step is to find the fuel pump, and use a test light to see if it is getting power when you open the air flow meter flap. Also, check to see if there is a heavy red wire from the double relay up to the positive post on the battery. If that is missing, nothing on your injection will work. Thanks Clay, I suspected that wire should be connected. Just to be clear, these are the 4 male connections on the rear left of the relay board. Which connector should I connect this wire to? |
Lo-Fi Version | Time is now: 9th June 2024 - 10:02 PM |
All rights reserved 914World.com © since 2002 |
914World.com is the fastest growing online 914 community! We have it all, classifieds, events, forums, vendors, parts, autocross, racing, technical articles, events calendar, newsletter, restoration, gallery, archives, history and more for your Porsche 914 ... |