 914 Tachometer not working |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| vin man |
 Feb 7 2017, 03:20 PM
Post
#1
|
|
Member  Group: Members Posts: 178 Joined: 19-February 10 From: Gilbert, Arizona USA Member No.: 11,380 Region Association: Southwest Region  |
I've done some searching and have not yet found a thread that I'm sure has been covered at some point.
The tach in my 72 does not work. The car was converted from fuel injection to carbs long ago. I believe the reason the tach does not work is because it is no longer getting a signal from the computer (no longer have an ECU in the car). How does one use the factory tach when I no longer have FI? In other car projects, I just ran a line from negative side of the coil to the back of the tach. But I don't think that will work here, will it? |
   |
 
|
  |
Replies
| timothy_nd28 |
Feb 8 2017, 10:01 AM
Post
#2
|
|
Advanced Member Group: Members Posts: 2,299 Joined: 25-September 07 From: IN Member No.: 8,154 Region Association: Upper MidWest 
|
12 pin connector is not the one by the firewall
|
|
|
|
| vin man |
Feb 8 2017, 10:18 AM
Post
#3
|
|
Member Group: Members Posts: 178 Joined: 19-February 10 From: Gilbert, Arizona USA Member No.: 11,380 Region Association: Southwest Region |
QUOTE(timothy_nd28 @ Feb 8 2017, 09:01 AM)  12 pin connector is not the one by the firewall Ok, thanks. When I go over to my workshop tonight after work, I will trace the black/purple wire out of the 12 pin connector and see where it goes. |
|
|
|
Posts in this topic
vin man 914 Tachometer not working Feb 7 2017, 03:20 PM
timothy_nd28 There is already a black with purple stripe wire t... Feb 7 2017, 04:19 PM The Cabinetmaker The djet cars have a large black power wire, a sma... Feb 7 2017, 04:28 PM vin man Thanks. On my way over to test as you suggest. Feb 7 2017, 04:28 PM vin man According the repair manual I have, the wire from ... Feb 7 2017, 07:06 PM The Cabinetmaker Green with red is the oil pressure sender. Feb 7 2017, 07:52 PM vin man That's right. Maybe the wire for the tech was ... Feb 7 2017, 08:02 PM timothy_nd28 I'm just curious, where was the black and purp... Feb 7 2017, 08:39 PM rdauenhauer Tim is there a way to simulate the signals to ... Feb 7 2017, 10:02 PM vin man The black with purple stripe wire came to this plu... Feb 7 2017, 10:09 PM timothy_nd28 20 bucks in Radio Shack parts and a Iphone (or sim... Feb 7 2017, 10:18 PM timothy_nd28 The black/purple stripe wire should enter on the 1... Feb 7 2017, 10:24 PM
vin man
The black/purple stripe wire should enter on the ... Feb 8 2017, 09:32 AM vin man
12 pin connector is not the one by the firewall
... Feb 8 2017, 10:15 AM |
2 User(s) are reading this topic (2 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 18th December 2025 - 02:01 AM |
Invision Power Board
v9.1.4 © 2025 IPS, Inc.