Home  |  Forums  |  914 Info  |  Blogs
 
914World.com - The fastest growing online 914 community!
 
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG. This site is not affiliated with Porsche in any way.
Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners.
 

Welcome Guest ( Log In | Register )

> What is the best way to prep e-coated parts?
doug_b_928
post Sep 6 2017, 09:17 AM
Post #1


Senior Member
***

Group: Members
Posts: 714
Joined: 17-January 13
From: Winnipeg
Member No.: 15,382
Region Association: Canada



I'm epoxy priming everything. But I see that e-coated parts don't need to be primed. However, some say that the part will match better if it is blasted and epoxy primed. What's the recommended procedure for e-coated parts (in his case the Dansk battery support and tray).
User is online!Profile CardPM
Go to the top of the page
+Quote Post
 
Reply to this topicStart new topic
Replies
mgphoto
post Sep 6 2017, 01:19 PM
Post #2


"If there is a mistake it will find me"
***

Group: Members
Posts: 1,375
Joined: 1-April 09
From: Los Angeles, CA
Member No.: 10,225
Region Association: Southern California



Red scuff pad then epoxy.

Some like to remove the ecoat.

Make sure it is ecoat, try lacquer thinner, if it rubs the ecoat off, remove it.

Epoxy primer will give the best surface to begin filler and high build primer.
User is offlineProfile CardPM
Go to the top of the page
+Quote Post

Posts in this topic


Reply to this topicStart new topic
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:

 



- Lo-Fi Version Time is now: 11th July 2025 - 05:25 AM