Home  |  Forums  |  914 Info  |  Blogs
 
914World.com - The fastest growing online 914 community!
 
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG. This site is not affiliated with Porsche in any way.
Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners.
 

Welcome Guest ( Log In | Register )

> 71 914 1.7 Engine boggs when warm
Bfstake
post Sep 21 2017, 08:49 PM
Post #1


Newbie
*

Group: Members
Posts: 5
Joined: 21-February 16
From: Atlanta
Member No.: 19,694
Region Association: South East States



Hi guys-
My 71 was recently converted back to FI (had a single carb). It starts up great and runs fine until it gets warmed up. After about 10 minutes of driving the motor seems to lose power while accelerating. Especially if I'm going up a hill or even a slight incline. If I let off the gas a little the motor seems to pull a little better, but still less than I need. So the more gas I give it, the more sluggish it gets.
Also, this may be a separate issue, but sometimes when warm and at idle it stalls and needs to cool off for several minutes before it'll start back up. I more interested in solving the lack of power issue as I've gotten accustomed to feathering the gas at stops. Or maybe they're related.

By the way I've moved the dial on the FI computer around and there's really no noticeable difference in the hot/sluggish issue.

Thanks all-
Bill in Atlanta
User is offlineProfile CardPM
Go to the top of the page
+Quote Post
 
Reply to this topicStart new topic
Replies
BeatNavy
post Sep 22 2017, 06:39 AM
Post #2


Certified Professional Scapegoat
****

Group: Members
Posts: 2,924
Joined: 26-February 14
From: Easton, MD
Member No.: 17,042
Region Association: MidAtlantic Region



The suggestions provided are all good and valid, but I'd also suggest that this could be classic case of running too rich. That would explain both symptoms (sluggish and low idle when warm). Running too rich can be caused by one or more of the following factors:

1. MPS that doesn't want to hold a vacuum anymore
2. CHT failing
3. Fuel Pressure too high
4. Leaking Cold Start Valve or other injector(s)
5. Worn/dirty trigger points
6. Disconnected / faulty T1 sensor (ambient air temp)

Feathering the throttle introduces more air that can help lean out the mixture a bit. That dial on the ECU is supposed to only be applicable to idle mixture. When the TPS "enters" the idle circuit the ECU controls mixture based on that knob. CCW will lean the idle mixture, CW will enrichen it. Try turning it iteratively CCW and see if it makes any difference at all while idling (when it's already warm). That's not a solution, but it may be additional info pointing to an overly-rich condition.
User is offlineProfile CardPM
Go to the top of the page
+Quote Post

Posts in this topic


Reply to this topicStart new topic
2 User(s) are reading this topic (2 Guests and 0 Anonymous Users)
0 Members:

 



- Lo-Fi Version Time is now: 2nd June 2024 - 02:10 AM