torque setting calculations |
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
torque setting calculations |
JFG |
Dec 2 2017, 02:39 AM
Post
#1
|
Senior Member Group: Members Posts: 686 Joined: 7-April 16 From: Wales Member No.: 19,869 Region Association: None |
I've discovered that my torque wrench only goes up to 160 ft lbs. I need another 50 ft lbs to lock up the rear drive shafts into the wheel bearing hub.
I have an angle gauge and was wondering if it is possible to convert the remaining 50 ft lbs into degrees for the angle gauge? |
Tbrown4x4 |
Dec 2 2017, 10:30 AM
Post
#2
|
Senior Member Group: Members Posts: 704 Joined: 13-May 14 From: Port Orchard, WA Member No.: 17,338 Region Association: None |
Sorry for the general, too detailed answer. Early in my mechanical career, I had 2 customers almost lose wheels on my account. I've been pretty anal about torque specs ever since. (I have 8 torque wrenches. Is that a cry for help? haha)
Sure, axle nut is less critical hardware. Don't you torque it and then tighten even more to line up the split pin anyway? |
Lo-Fi Version | Time is now: 22nd May 2024 - 10:07 PM |
All rights reserved 914World.com © since 2002 |
914World.com is the fastest growing online 914 community! We have it all, classifieds, events, forums, vendors, parts, autocross, racing, technical articles, events calendar, newsletter, restoration, gallery, archives, history and more for your Porsche 914 ... |