torque setting calculations |
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
torque setting calculations |
JFG |
Dec 2 2017, 02:39 AM
Post
#1
|
Senior Member Group: Members Posts: 686 Joined: 7-April 16 From: Wales Member No.: 19,869 Region Association: None |
I've discovered that my torque wrench only goes up to 160 ft lbs. I need another 50 ft lbs to lock up the rear drive shafts into the wheel bearing hub.
I have an angle gauge and was wondering if it is possible to convert the remaining 50 ft lbs into degrees for the angle gauge? |
Andyrew |
Dec 3 2017, 11:01 AM
Post
#2
|
Spooling.... Please wait Group: Members Posts: 13,376 Joined: 20-January 03 From: Riverbank, Ca Member No.: 172 Region Association: Northern California |
Ive never torqued the stub axle. I use my cheater bar and pretty much put all my weight on it.
I even leave the cotter pin out. I take out the cv joints with the stub instead of the bolts on the outside as it saves me way to much time. |
Lo-Fi Version | Time is now: 22nd May 2024 - 09:04 PM |
All rights reserved 914World.com © since 2002 |
914World.com is the fastest growing online 914 community! We have it all, classifieds, events, forums, vendors, parts, autocross, racing, technical articles, events calendar, newsletter, restoration, gallery, archives, history and more for your Porsche 914 ... |