 Two Questions - Wires and Heat exchangers, Two questions |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| simonjb |
 Dec 29 2017, 03:32 PM
Post
#1
|
|
KiwiMan  Group: Members Posts: 563 Joined: 18-October 16 From: Stamford, Connecticut Member No.: 20,505 Region Association: North East States 
 |
Hi
Two questions.. 1) Can I rest the engine on the ground with the heat exchangers attached? Without any damage? 2) I am trying to figure out these wires - the two at the bottom of pic. One is a single wire and the other is a set. I assume one is for inside light? Whats the second set for?  |
   |
 
|
  |
Replies
| Spoke |
Dec 30 2017, 07:48 PM
Post
#2
|
|
Jerry Group: Members Posts: 6,991 Joined: 29-October 04 From: Allentown, PA Member No.: 3,031 Region Association: None
|
QUOTE(simonjb @ Dec 29 2017, 04:32 PM)  1) Can I rest the engine on the ground with the heat exchangers attached? Without any damage? When you say "with heat exchangers attached" do you mean with transmission attached and the end of the HEs attached to the muffler hanger? If the trans is not attached I'm not sure I would rest the engine on the HEs. |
|
|
|
Posts in this topic
simonjb Two Questions - Wires and Heat exchangers Dec 29 2017, 03:32 PM
mepstein
Hi
Two questions..
1) Can I rest the engine on ... Dec 29 2017, 03:51 PM gothspeed I believe the longer solo wire (lower left in pict... Dec 30 2017, 12:26 AM Dave_Darling You can store the engine that way, but I prefer to... Dec 30 2017, 04:14 PM GeorgeRud I’d try to support the main engine weight under ... Dec 31 2017, 09:15 AM mepstein If you are leaving the trans and exhaust on the ca... Dec 31 2017, 09:41 AM rhodyguy The 1000# rated furniture dolly from Home Depot. ... Dec 31 2017, 09:44 AM
mepstein
The 1000# rated furniture dolly from Home Depot. ... Dec 31 2017, 10:27 AM rjames I personally wouldn’t use the exchangers to supp... Dec 31 2017, 01:40 PM mepstein
I personally wouldn’t use the exchangers to sup... Dec 31 2017, 01:56 PM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 6th June 2024 - 02:52 PM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.