Home  |  Forums  |  914 Info  |  Blogs
 
914World.com - The fastest growing online 914 community!
 
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG. This site is not affiliated with Porsche in any way.
Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners.
 

Welcome Guest ( Log In | Register )

> Yet ANOTHER flaher relay issue, indicator light blinks w/o turn signals on
StarBear
post Jun 11 2018, 06:31 AM
Post #1


Senior Member
***

Group: Members
Posts: 1,906
Joined: 2-September 09
From: NJ
Member No.: 10,753
Region Association: North East States



Have had my ’74 1.8L since new and this problem just started – the single turn signal indicator light does a steady flash, once every 5-6 seconds, for no (?) apparent reason, all by itself. The relay clicks and sounds as expected, but the turn signals aren’t on (they all work just fine) and the parking brake switch seems OK. Changed out the relay (3 times – the URO replacement), cleared up all turn signal connectors and replaced all signal bulbs. All fuses look good. This had been an intermittent situation for a few weeks, but now it’s all the time. Went away for 20 minutes when replaced the relay the second time, but came back. Seems like a square wave signal is getting sent to the flasher relay? Any clues as to what’s going on?
Thanks!
User is offlineProfile CardPM
Go to the top of the page
+Quote Post
 
Reply to this topicStart new topic
Replies
Spoke
post Jun 11 2018, 03:11 PM
Post #2


Jerry
*****

Group: Members
Posts: 6,989
Joined: 29-October 04
From: Allentown, PA
Member No.: 3,031
Region Association: None



QUOTE(StarBear @ Jun 11 2018, 08:31 AM) *

Changed out the relay (3 times – the URO replacement)


So you've been through 3 relays and all do this slow flash?

When you say 5-6 seconds, is this 3 seconds on, 3 seconds off or different?

If all 3 relays do the same thing, it seems you may have some sort of leak either through the brake switches (ebrake and master cylinder brake).

You can check the brake switch by removing the brake warning bulb (temporarily) and see if the slow flash stops.

BTW, the turnsignals will only come on if the stalk is pushed for L or R turnsignals or the 4-way flasher switch is engaged.
User is offlineProfile CardPM
Go to the top of the page
+Quote Post
StarBear
post Jun 12 2018, 05:47 AM
Post #3


Senior Member
***

Group: Members
Posts: 1,906
Joined: 2-September 09
From: NJ
Member No.: 10,753
Region Association: North East States



It goes on briefly for 1 second (not too slowly nor too quickly) then off for 4-5 seconds, then back on. Sort of like a short "square wave" signal coming from somewhere (or being generated by the flasher itself). Yes, quite unusual for all 3 to exhibit the same characteristic.


QUOTE(Spoke @ Jun 11 2018, 05:11 PM) *

QUOTE(StarBear @ Jun 11 2018, 08:31 AM) *

Changed out the relay (3 times – the URO replacement)


So you've been through 3 relays and all do this slow flash?

When you say 5-6 seconds, is this 3 seconds on, 3 seconds off or different?

If all 3 relays do the same thing, it seems you may have some sort of leak either through the brake switches (ebrake and master cylinder brake).

You can check the brake switch by removing the brake warning bulb (temporarily) and see if the slow flash stops.

BTW, the turnsignals will only come on if the stalk is pushed for L or R turnsignals or the 4-way flasher switch is engaged.

User is offlineProfile CardPM
Go to the top of the page
+Quote Post

Posts in this topic


Reply to this topicStart new topic
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:

 



- Lo-Fi Version Time is now: 2nd June 2024 - 01:55 AM