 Transmission Blasting, Aluminium Oxide 100 grit OK |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| rstover |
 Nov 28 2018, 08:34 PM
Post
#1
|
|
Member  Group: Members Posts: 136 Joined: 15-November 11 From: Austin, TX Member No.: 13,785 Region Association: Southwest Region  |
I recently had the fan housing cerakoted and now I want to do the transmission. On the fan housing I removed all the grease and oil and the shop that applied the cerakote blasted it withe 200 grit aluminium oxide in a cabinet and it came out great.
I will get all the grease and oil off the transmission, but the blasting will be done with 100 grit aluminum oxide outside of a cabinet. I believe I have protected everything but was a little concerned about 100 grit being to course.  |
   |
 
|
  |
Replies
| mepstein |
Nov 28 2018, 08:58 PM
Post
#2
|
|
914-6 GT in waiting Group: Members Posts: 20,217 Joined: 19-September 09 From: Landenberg, PA/Wilmington, DE Member No.: 10,825 Region Association: MidAtlantic Region 
|
I would only soda blast unless you intend to overhaul the trans after blasting.
|
 |
|
Posts in this topic
rstover Transmission Blasting Nov 28 2018, 08:34 PM
rstover
I would only soda blast unless you intend to over... Nov 28 2018, 09:11 PM
wes I cleaned mine up getting rid of all the oily mess... Nov 28 2018, 09:08 PM IronHillRestorations I've only used crushed walnut shells for whole... Nov 28 2018, 09:12 PM rstover
I've only used crushed walnut shells for whol... Nov 28 2018, 09:46 PM mepstein Dry ice would be another way to go but I wouldn’... Nov 29 2018, 06:53 AM toolguy I wouldn't use sand. . I doubt that any tape ... Nov 29 2018, 09:44 AM ValcoOscar
I wouldn't use sand. . I doubt that any tape... Nov 29 2018, 10:37 AM Dr Evil
I wouldn't use sand. . I doubt that any tape... Nov 29 2018, 01:48 PM brant I agree with all of the above comments
to the OP
... Nov 29 2018, 10:18 AM rstover Thanks for all the responses. I have spent about ... Nov 29 2018, 06:48 PM cary We do quite a few gear boxes at Rothsport. 1 to 2 ... Nov 29 2018, 11:02 PM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 8th November 2025 - 09:50 AM |
Invision Power Board
v9.1.4 © 2025 IPS, Inc.